Retailers Support & Downloads

La liste ci-dessous répertorie les catégories de système prises en charge. Chaque section contient des logiciels, des mises à jour, des pilotes d’imprimante Windows, des correctifs, des manuels et des profils de couleurs applicables au système.

 

Announcements

Select the system to find updates, patches, firmware, content, user guides and more.

APEX

Select your APEX System to find available updates and patches

KODAK 70XX Photo Printer Firmware V29.00 for the KODAK Adaptive Picture Exchange

Installs firmware V29.00 on KODAK 70XX Photo Printers
Adds image quality improvements for 7000-5R printers.

Release Date
Installation Instructions

Installing the KODAK 70XX Photo Printer Firmware V29.00on the KODAK Adaptive Picture Exchange


Install the firmware on all 70XX Printers connected to your KODAK Adaptive Picture Exchange (APEX system).


IMPORTANT: Before you begin, make sure that:
• All 70XX Printers are connected, and listed as FOUND in Device
Health Check.
• Each 70XX Printer indicates a “Ready” status on the display of the printer.


1. Make sure that the power for the printer(s) is on, and “Ready” appears on the display.
2. From the Main screen of the APEX system, select [Setup]. Enter the password if necessary.
3. Select:
• [Install]
• [Install Software]
4. At “Software Installation. Please insert installation media...”:
• Insert the CD into the CD drive.
• Wait approximately 10 seconds.
• Select [Check for Media].
5. At “Installation media was found”, select [Yes].
6. At “Ready to Install”, select [Install].
When installation is complete, the system restarts.
7. Remove and store the CD in the software wallet.
8. Does “Ready” appear on the display of the printer(s)?


Yes -The Firmware is now installed on all 70XX Printers connected to the APEX system.  Continue with “Verifying that the Firmware is Installed” on page 2.

No - Install the firmware again. If “Ready” still does not display on the printer, contact Service and Support.

Verifying that the Firmware is Installed
1. From the Main screen of the APEX system, select [Setup]. Enter the password if necessary.
2. Select:
• [Diagnostics]
• [Health Checks]
• [Application Health Checks]
3. Verify that “KODAK 70XX Printer FW V29.00” appears.
4. If “KODAK 70XX Printer FW V29.00” does not appear, install the
firmware again. If it still does not appear, contact Service and Support.
5. Select:
• [Done]
• [Done]
• [Done]


Resetting the Printer Calibration
IMPORTANT: Make sure the firmware is installed before you reset the calibration.
1. From the Setup screen of the APEX system, select [Manage Devices].
2. Select [Thermal Printers].
3. Select the KODAK 70XX Photo Printer.
4. Select [Reset Calibration to Default].
5. Select [Yes] at the prompt.
6. Repeat Steps 3-5 for each additional 70XX Printer.
7. Select:
• [Done]
• [Done]
• [Done]