Retailers Support & Downloads

Listed below are the system categories supported.  Each section contains software, updates, Windows printer drivers, patches, manuals and color profiles applicable to the system.

 

Announcements

Select the system to find updates, patches, firmware, content, user guides and more.

KODAK Picture Kiosk

Select your KODAK Picture Kiosk System to find the latest software and content updates

KODAK 8810 Photo Printer Firmware V6.01

This release makes minor improvements to panoramic printing.

This release will install on APEX+/KPK+ V9.1 and later. Earlier versions of APEX/KPK SW do not support this firmware (they need to continue to use V5.24 firmware).

Release Date
Installation Instructions

Install the firmware on all 8810 Printers connected to your Kiosks. Installation will take approximately 10 minutes.

IMPORTANT: Before you begin, make sure that:

• All 8810 Printers are connected, and listed as FOUND in Device Health Check.

• Each 8810 Printer indicates a “Ready” status on the display of the printer.

• KODAK Adaptive Picture Exchange V9.1 or later, or KODAK Picture Kiosk Plus Software Version 9.1 or later is installed on your Kiosk.

1. Make sure that the power for the printer(s) is on, and “Ready” appears on the display.

2. From the Main screen, touch [Setup]. Enter the password if necessary.

3. Touch [Install Software].

4. Insert the CD into the CD drive, or the USB Thumb Drive into an available USB Port.

5. At “Software Installation”, touch [Check for Media].

6. At “Installation CD Detected”, touch [Install].

When installation is complete, the CD ejects and the Kiosk restarts.

7. Remove and store the CD or USB Thumb Drive in the software wallet.

8. At, “Installation Complete”, touch [OK].

9. Does “Ready” appear on the display of the printer(s)?

Yes - Continue with “Verifying that the Firmware is Installed” below.

No - Install the firmware again. If “Ready” still does not display on the printer, contact Service and Support.



The Firmware is now installed on all 8810 Printers connected to your system.



Verifying that the Firmware is Installed

1. From the Main screen, touch [Setup]. Enter the password if necessary.

2. Touch [Diagnostics].

3. Touch [Application Health Check].

4. Verify that “KODAK 8810 Photo Printer Firmware v6.01” appears.

5. If “KODAK 8810 Photo Printer Firmware v6.01” does not appear, install the firmware again. If it still does not appear, contact Service and Support.

6. Touch:

• [Continue]

• [Start Over]



Resetting the Printer Calibration

IMPORTANT: Make sure the firmware is installed before you reset the calibration.

1. From the Setup screen of the Kiosk, touch [Manage Devices].

2. Touch [KODAK 8810 Photo Printer Options].

3. Touch [Reset Factory Calibration].

4. Touch [Yes] at the prompt.

The following message appears:

“Reset calibration succeeded.”

5. Touch [OK].

6. Touch:

• [Start Over]

• [Exit]