Retailers Support & Downloads

La liste ci-dessous répertorie les catégories de système prises en charge. Chaque section contient des logiciels, des mises à jour, des pilotes d’imprimante Windows, des correctifs, des manuels et des profils de couleurs applicables au système.



Select the system to find updates, patches, firmware, content, user guides and more.

KODAK Picture Kiosk

Select your KODAK Picture Kiosk System to find the latest software and content updates

KODAK 6900 V3.20 / 6950 V4.40 Photo Printer Firmware

Installs firmware V3.20 on KODAK 6900 Photo Printers, and firmware V4.40 on KODAK 6950 Photo Printers.  6950 Firmware V4.40 modifies the skew correction process which contains a countermeasure for Paper Jam 01. Skew correction occurs at the end of the job. 6900 Firmware is unchanged but is re-packaged in the firmware package with the 6950 Firmware V4.40.

This release will install on any KPEX+ systems.

Hardware Prerequisite: If you have a KODAK cabinet with a 6950 printer, the 6950 print bin introduced in 2021 (part number 4M0791) needs to be installed at the same time or prior to deploying this firmware update. This prerequisite does not apply to 6900 printers.

Release Date
Installation Instructions

Installing the Kodak 6900 V3.20 / 6950 V4.40 Photo Printer Firmware

Install the firmware on all 6900 and 6950 printers.

IMPORTANT: Before you begin, make sure that:
• All Printers are connected, and listed as FOUND in Device Health Check.
• Each Printer indicates a “Ready” status on the display of the printer.

1. Make sure that the power for the printer(s) is on, and “Ready” appears on the display.
2. From the Main screen of the Kiosk, touch [Setup]. Enter the password if necessary.
3. Touch [Install Software].
4. Insert the CD into the CD-RW drive, or the USB Thumb Drive into an available USB Port.
5. At “Software Installation”, touch [Check for Media].
6. At “Installation CD Detected”, touch [Install].
7. At “Ready to Install the Program”, touch [Install].
Wait while the firmware is installed. This can take up to 5 minutes per printer.
The Kiosk restarts.
8. Does “Ready” appear on the printer(s)?

Yes - Continue with Step 9.

No - Install the firmware again. If “Ready” still does not appear
on the printer, contact Service and Support.

9. At “Installation Complete”:
• Remove and store the CD or USB Thumb Drive in the software wallet.
• Touch [OK].
The Printer Firmware is now installed on all 6900 and 6950 Printers.
Verify that the Firmware is Installed
1. From the Main screen of the Kiosk, touch [Setup]. Enter the password if necessary.
2. Touch:
• [Diagnostics]
• [Application Health Check]
3. Verify that “Kodak 6900 V3.20 / 6950 V4.40 Photo Printer Firmware” appears.
4. If “Kodak 6900 V3.20 / 6950 V4.40 Photo Printer Firmware” does not appear, install the
firmware again. If it still does not appear, contact Service and Support.
5. Touch:
• [Continue]
• [Start Over]