Retailers Support & Downloads

Listed below are the system categories supported.  Each section contains software, updates, Windows printer drivers, patches, manuals and color profiles applicable to the system.


Select the system to find updates, patches, firmware, content, user guides and more.

KODAK Picture Kiosk

Select your KODAK Picture Kiosk System to find the latest software and content updates

68XX Printer Firmware Jan 2024

For optimal image quality, use the following link to download the most up to date color profile package and firmware for the 6800 and 6850 printers.

KODAK 68XX Printer Firmware Jan 2024
6800 Printer V261/361/461
6850 Printer V679/879
NOTE: To use the "Energy Save" feature which is included from previous releases of this printer firmware, the target kiosk must have KPEX+ V23.2 or higher installed. 
Release Date
Installation Instructions

Install the firmware on all 68XX Printers connected to a KODAK Picture Kiosk



Before you begin, make sure that:

  • All Printers are connected, and listed as FOUND in Device Health Check.
  • Each Printer indicates a "Ready" status on the display of the printer.
  1. Make sure that the power for the printer(s) is on, and "Ready" appears on the display.
  2. From the Main screen of the Kiosk, select [Setup]. Enter the password if necessary.
  3. Touch [Install Software]
  4. Insert the CD into the CD drive, or the USB Thumb Drive into an available USB Port..
  5. At “Software Installation”, touch [Check for Medial].
  6. At “Installation CD Detected”, touch [Install].
  7. At “Ready to Install the Program”, touch [Install].
    Wait while the firmware is installed.  This can take up to 5 minutes per printer.  The Kiosk restarts.
  8. Does “Ready” appear on the printer(s)?

    Yes No
    Continue with "Step 9". Install the firmware again. If "Ready" still does not display on the printer, contact Service and Support.
  9. At "Installation Complete":
    • Remove and store the CD or USB Thumb Drive in the software wallet.
    • Touch [OK].

The Printer Firmware is now installed on all 6800/6850 Printers connected to your Kiosk.

Verifying that the Firmware is Installed

  1. From the Main screen of the Kiosk, touch [Setup]. Enter the password if necessary.
  2. Touch
    • [Diagnostics]
    • [Application Health Check]
  3. Verify that “68XX Printer Firmware December 2017” appears.
  4. If “68XX Printer Firmware December 2017” does not appear, install the firmware again. If it still does not appear, contact Service and Support.
  5. Touch:
    • [Continue]
    • [Start Over]

Resetting the Printer Calibration

 IMPORTANT: Make sure the firmware is installed before you reset the calibration.

  1. From the Setup screen of the Kiosk, touch [Manage Devices].
  2. Touch [KODAK Photo Printer 6800/6850/605 Options].
  3. Do you have two 6800/6850 Printers?

    Yes No
    Select a printer.. Continue with Step 4.


  4. Touch
    • [Reset Factory Calibration]
    • [Yes] at the prompt
      The following message appears:
      "Reset calibration succeeded."
  5. Touch:
    • [OK]
    • [Previous]
  6. Repeat steps 3 - 5 if you have a second 6800/6850 Printer.
  7. Touch:
    • [Start Over]
    • [Exit]